To place a file on a scanned workspace, tap 'Import' in the upper left corner of the screen when you are in Design mode.
Tap USB to place a design that is stored on your USB drive. Tab My Hub to add a design you added from ShaperHub.
After tapping on a design, you will see it overlaid on your Workspace. Move Origin around to adjust where it gets placed. The white square represents the current location of your bit.
When you are happy with the location of your design, tap the green button to Place.
Placing with a Grid
If you have added a grid to your workspace, the anchor point on your design will snap to gridlines. To change which anchor point is used, tap Anchor on the left menu. You can then select one of nine points.
The location of the anchor point is given in x,y coordinates in the top right-hand corner of the screen.
To freely place your design without snapping to the grid, you can toggle the Snap setting.
You can use the zoom bar on the right side of the screen to zoom in or out in your workspace for precise placement.
To change the size of your design prior to placement, tap the Scale icon. You can then set the width and/or height of your design. When the Proportional setting (chain icon) is enabled, the other dimension will automatically adjust to ensure that your design doesn't become distorted.
To distort your design, you can disable the Proportional setting.
Rotating a Design
You can also rotate your design. You can use the preset values or enter a specific degree of rotation.