The left side of the Control Center is known as the Pass Summary. It contains a list of the passes which will be completed in order to reach your total cut depth. Each pass is shown with its depth and offset.
+/- buttons are shown at the bottom of the pass summary. You can use the +/- buttons to quickly add or subtract passes from your pass summary without needing to manually modify the pass depth parameter. Pressing the +/- buttons will automatically adjust the pass depth parameter as needed to give you your desired number of equidistant passes.
Before pressing the - button | After pressing the - button |
The maximum allowable number of passes is 50. AutoPass will not allow you to exceed this number.