Troubleshooting on Long Cut Operations

Long, narrow stock can be prone to scanning distortions when cutting with Origin, but there are techniques that you can use to reduce this distortion and improve your cut precision.

During scanning, Origin surveys the distance between each marker on the workspace.
You can think of each of these measurements as structural elements, each with a tiny amount of flexibility. That flexibility can cause distortion, so we want reduce the total amount of flexibility in any given scan.

Example of an ineffective taping strategy on long, narrow stock

The stock is symbolized in grey. The measurements made during scanning are represented as green lines:

Think of the marker measurements Origin sees as structural reinforcing. The following structure is not well braced, and as a result is very flexible:

The result is a distorted workspace:

If all the green measurements are treated as slightly flexible we can see the resulting spindly structure is not very rigid. To strengthen things, we need to 'cross-brace' our structure

Example of a modest improvement

This won't be adequate for a 10 foot-long cut, but it's an improvement on our initial layout:

The surveyed “structure” Origin creates when it scans and locates the tape markers:

The triangular “reinforcing” reduces distortion significantly:

By moving the tape to the edge of our stock, we get a wider and 'stronger' structure. The distance between parallel dominos is reinforced by additional adjacent measurements

We still run the risk of running low on visible markers while cutting, especially if we cut through some or if they get dust on them. So let's see if we can further “strengthen” our scan structure.

Example of an effective taping strategy

Add a tape board (symbolized in white) alongside the stock (in grey) we intend to cut:

Below we see what happens when we add a tape board alongside the stock we intend to cut.
Here we are confident Origin 

1. will always be able to see 5+ markers during the cutting process, (Origin's sight symbolized in blue)
2. will not need to be rotated while cutting. Keeping Origin facing in the same general direction throughout a scan and cut will help keep your cuts precise.

Note: The surface of the additional board must be on the same level as of the workpiece - see this article.

Adding a parallel tape board also provides greater stability for Origin's skid pad as you travel along your cut. Marker measurements reinforce one another. Resulting in minimal distortion:

As you are not cutting into the tape board you can leave it taped up and use it again in the future.

[Note: the measurement lattice shown here is simplified for clarity. In reality, all markers recorded by the camera in an image have measurement lines connecting them.]