Skip to content
English
Contact us
Go to shapertools.com
  • There are no suggestions because the search field is empty.

Pass Summary

The left side of the Control Center is known as the Pass Summary. It contains a list of the passes which will be completed in order to reach your total cut depth. Each pass is shown with its depth and offset. 

EN-5.png

+/- buttons are shown at the bottom of the pass summary. You can use the +/- buttons to quickly add or subtract passes from your pass summary without needing to manually modify the pass depth parameter. Pressing the +/- buttons will automatically adjust the pass depth parameter as needed to give you your desired number of equidistant passes.

EN-7.png EN-6.png

Before pressing the - button

After pressing the - button

The maximum allowable number of passes is 50. AutoPass will not allow you to exceed this number.