To enable unobstructed access to change the router bit, the SM1 Spindle must be removed from Origin. IMPORTANT: Always unplug the SM1 Spindle from Origin before removing the spindle from the spindle mount. Use the included 4mm T-handle hex wrench to loosen the spindle mount bolt. Once loosened, lift the spindle to remove it.
To reinstall the spindle, slide it into the spindle mount with the ON/OFF switch facing towards you. A groove on the back of the spindle will only allow it to be inserted in the correct orientation, with the cable exiting on the left side. Gently re-insert the spindle as to not deform the alignment pin. IMPORTANT: Be sure to tighten the spindle mount bolt after fully inserting the spindle into the spindle mount. Finally, ensure the switch is in the “OFF” position and plug the spindle cable back into the side of Origin.