Once you have placed your design in your workspace, it is a good idea to 'travel' over your cut lines with Origin, cutting in Aircut mode. Keep an eye on your tape indicator in the upper right-hand corner of the screen. If at any point it dips below half-full, we suggest that you add more tape to your workspace and Update your Scan.
After adding new tape, tap 'Scan' to return to scan mode. Then tap the 'Update Scan' tool to add to your current scan. NOTE - Updating a scan will clear your cut history. All of your designs, however, will remain in place. It also deletes any grid you may have laid down.
When ready, tap the green button on the right handle to begin scanning. Be sure to scan your entire workspace again, not just the location of the new tape. When you have completed your scan, tap the green button again. Your workspace will now include the new tape.
Keep in mind that you can continue to Update Scan as you cut. If you cut through dominos, Origin will be unable to read them. Simply remove the cut or unreadable dominos (they are the dominos that do not show up blue during scanning) from your workspace. Then reapply tape on uncut portions of your workpiece or on your surrounding coplanar workspace, and Update Scan again.