This is highly dependent on the material, cutter and offsets you are using (more here). You can see more about offsets It is not uncommon for us to perform light sanding operations on pieces to remove fuzz before fitting them together.
Articles in this section
- Getting Emails From Shaper
- What is Shaper Origin?
- How does Shaper Origin work?
- What can I make?
- How large of a project can Origin handle?
- What is ShaperHub?
- How can I get updates about Origin?
- How long does it take to set up Origin?
- What software can I use with Origin?
- Is Origin secure?