The limitations to what Origin can correct are based on depth of cut and the speed at which you go out of bounds of the corrective range. If you are cutting a reasonably shallow depth and you do not fly out of bounds, the bit can retract quickly enough to not leave a mark. If you are drilling a 1-inch deep hole and push aggressively out of the corrective range, the bit will almost certainly leave a mark as it retracts out of the material. We are continuously making improvements to bit retraction speed and also our algorithms to help improve cut quality, for example via predictive motion path compensation. But if cut/finish quality is the paramount concern, we recommend performing bulk material removal at an offset from the final intended path, and a finish pass where only a small amount a material needs to be removed by the cutter. The ability to return to the workpiece to shave off just a hair more of material is really one of the magic qualities of Origin that change the way you’re able to create.
Articles in this section
- Getting Emails From Shaper
- What is Shaper Origin?
- How does Shaper Origin work?
- What can I make?
- How large of a project can I tackle?
- What is ShaperHub?
- How can I get updates about Origin?
- How long does it take to set up Origin?
- What software can I use with Origin?
- Is Origin secure?